lpg reducer is developing very fast, and it has been bringing people the most convenient products. Of course, we need to understand its installation and operation steps, so everyone knows what are the installation steps of lpg reducer factory to share the hard tooth surface reducer?

The following lpg reducer manufacturers share the installation steps of hardened reducer:

1. Rotate one of the gears 180 degrees. That is, when the middle bearing hole and the ten hole are completely coincident, the external tooth profile is just dislocated.

2. Put a piece of gear into the pin-tooth shell, and turn it by hand to see if it is smooth and whether it swings.

3. Put in the eccentric bearing, because the bearing hole of the gear is equivalent to the outer casing of the eccentric bearing.

4. Insert the spacer ring.

5. Put another piece of lpg reducer gear. The key is to put this wheel. The position should be completely based on the last mark you drew.

6. Put on the shaft sleeve and turn it by hand to see if it can be turned and check whether the installation is correct.

The lpg reducer is a relatively precise machine, the purpose of using it is to reduce the speed and increase the torque. When all of us install lpg reducer, we can follow the above installation steps to install it. It is very important for us to install lpg reducer correctly.